First, product features

Power sealant for flame retardant dealcoholized one component room temperature curing silicone sealant. The product model ZS-NJ-D52l high strength, adhesion is good, on a variety of metal aluminum, copper, stainless steel has good adhesion; superior dielectric properties, good heat resistance, general use temperature range of - 60 DEG C to 200 degrees. The release of the curing process is alcohol, the polycarbonate (PC), copper and other materials without corrosion, in full compliance with the EU ROHS directive requirements.

Two, typical use

Power adapter, a circuit board connector fixed; electronic components sealed, fixed, earthquake, such as high pressure package, week, electrical plugs, rectifier tube and capacitance of the joint protection.

Three, the use of Technology

1: clean the surface will be sticky or coated with the surface clean and remove rust, dust and oil etc..

2, sizing: unscrew the hose (or cut open) blocks, glue onto the surface has been cleaned, the uniform distribution can be.

3, curing: will be adhered to good or sealed parts in the air to let the natural curing. Curing process is a from the surface to the internal curing process and in 24 hours (55% at room temperature and relative humidity) adhesive cured 2 ~ 4mm depth, if applied to the deep location of glue, especially not easy to come into contact with air site, completely curing time will be extended, if the temperature is relatively low, curing time will be extended, 6mm thick sealant to be fully cured more than 7 days time.

Four, matters needing attention

After the power supply sealant is applied, the rubber is not used up and the cap is tightened immediately. Once again, if the seal is a little skin, remove it, do not affect the normal use of the. Glue in the process of storage, mouth also may be a small amount of curing phenomenon, will be cleared after normal use, does not affect the performance of the products.

Five, packaging specifications

2.6L/ branch, 4 branch / box.

Six, storage and transportation

25, 1 degrees below the cool and dry environment for 6 months, more than the shelf life of the product should be confirmed without exception before use.

2, such products are non - dangerous goods, according to the general chemical transport. Be careful in the course of transportation!

Seven, recommendations and statements

It is recommended that the user do the test before the formal use of the power supply sealant. Due to the diversity of practical application, our company does not guarantee specific conditions using our products appear problem, assume no responsibility for any direct, indirect or consequential or incidental damages, the user in the use of the process encountered any problems, contact our after-sales service department. We will strive to provide you with help.